How To Solve Dead Mobile In OK Condition !! Class 6 !! Mobile repairing Tracing course !!Dead mobile - Mobile Repairing Free Course

Mobile Repairing Free Course

Mobile repairing free course provides you all hardware and software knowledgw about mobile repairing.It provide you all knowledge that is provides by many institute in mobile repairing sector.

How To Solve Dead Mobile In OK Condition !! Class 6 !! Mobile repairing Tracing course !!Dead mobile

Share This

 Set Dead In OK Condition:-

Step 1- Check Battery Connector. Clean It By Blades.

Step 2-Check Battery voltage  by multimetre of 3.7v.

Step 3-In Tablet,Check voltage of 4.0v.

Step 4-Check Mobile By Connecting To Computer.Connect karne par communication bana raha hai.Means Mobile Hardware se Ok hai Software Karna hai.

Step 5-Mobile Board ko Fully Service Karna Hai.Normal Heat Dena Hai.

Step 6-On-Off Switch Par Voltage Check Karna Hai.On-Off Switch Par 1.8-3.7 tak ka voltage check karna hai.

Step 7-On-Off Switch Par Voltage Nhi Show Karne Par Uska Track Check karna hai.Track Find Kar Ke Jumper Yar Kisi Kisi Set Me Power Ic Se connection aati hai us set me Power Ic ko HRC(Heat,Reball,Change) Karna hai.

Step 8-On-Off Switch Par Voltage Show Karne Par:-



    8.1-Set ko fully servicing karna hai.
    8.2-Set ko conputer se check karna hai.
    8.3-Set ko connect karne par Boot Error show kare to Flash 
         IC aur Power IC ko Heat Dena hai aur phir Software Dalna hai.
    8.4-Set Agar boot na le to Power IC ke paas VCore,Vio,V.Flash and Npc ko One by One Resold Karna hai ya Replace Karna hai.
      8.5-Power IC,RF IC,Oscillator Crystal and Npc ko One by One HRC karna hai.
    8.6-Finally Power IC ko HRC karna hai.

Note:-*Ok Condition me agar Battery Drinking Ki Problem aati hai to Software Daalenge.If problem not solve then,Change the Battery.

Also Read:-How To Check Dead mobile with Multimetre

                    How To Solve Dead Mobile In Sorting & Leakage & Open Condition

                   How To Jumper In Mobile Phones

No comments:

Post a Comment